This fixture is manufactured from 17-4 Stainless Steel which is heat treated to H-1150.

Raptor Dovetail Fixtures are made to hold your part on Five Axis and Horizontal milling CNC machines. The fixtures provide rigid clamping while exposing five faces of the workpiece.  Most features can be completed in a single operation.  Our unique Raptor Dovetail spring-loaded clamps require only .125 - .250" of material to hold the workpiece.  That means less waste, easier prep and no distortion.  You prepare all your parts with a single dovetail and utilize the same fixture for every part.  Easy, strong and efficient.

Patent Pending

• Fixtures must be bolted down firmly to your Pallet or Table using the screws provided.
• Do not alter or replace any screw, spring or clamp with anything other than the exact item provided.
• Tighten clamps only to published torque limits. Do not exceed torque limits.
• When machining your workpiece with the dovetail it is critical that you follow our sketches. Failure to do so may result in the workpiece coming loose and or damage to your fixture. Pay close attention to required sizes and radius requirements on the sketches.
• Failure to follow these instructions may result in injury or damage to your workpiece, tools, fixtures and/or machine.

Qty of three RWP-CL3001 Clamps
Qty of three 5/8-11 Socket head cap screws
Qty of one 3/8-16 X 1/2 Low Profile Socket Head Cap Screw
Qty of two 1/2 x 1.0 Pull Dowel Pin
Qty of one 1/2 Hex Impact Key 1/2 drive
Qty of three .850 x .072 x 1.5 stainless springs
Qty of six 1/2-13 X 1.5 Socket Head Cap Screws