The RWP-T450 is a Tombstone for Horizontal milling applications. It Utilizes any of these fixtures to hold your workpiece:
• RWP-001
• RWP-002
• RWP-002SS
• RWP-001SS
• RWP-004

This 450 MM Tombstone includes:
8” Diameter Upright Column that is 23” Tall
Pallet 450 MM Pallet Size
4 Sided Pallet
12 Raptors (three per side)
The Round Tombstone gives you greater access than typical square Tombstones
Custom materials, Tombstone sizes  and configurations can be ordered.
When you order please specify why fixtures you want mounted to your Tombstone (RWP-001 or RWP-002).
NOTE:  The price will increase if you require the stainless Steel Fixtures (RWP-001SS or RWP-002SS)

Not an off the shelf Item.
Lead time is 4 – 6 Weeks.

• Fixtures must be bolted down firmly to your Pallet or Table using the screws provided.
• Do not alter or replace any screw, spring or clamp with anything other than the exact item provided.
• Tighten clamps only to published torque limits. Do not exceed torque limits.
• When machining your workpiece with the dovetail it is critical that you follow our sketches. Failure to do so may result in the workpiece coming loose and or damage to your fixture. Pay close attention to required sizes and radius requirements on the sketches.
• Failure to follow these instructions may result in injury or damage to your workpiece, tools, fixtures and/or machine.

Qty of twelve Raptor Dovetail fixtures
Qty of one Tombstone (Includes base and Upright)